Emerson ControlWave MICRO Instruction Manual download pdf (Page 55)

ControlWave Micro Instruction Manual (CI-ControlWave Micro)

Revised Jun-2013 I/O Modules 3-1

Chapter 3 – I/O Modules

This chapter discusses the placement and wiring for I/O modules for the

ControlWave Micro. The chapter begins with some general instructions

on module installation that are common to most I/O modules. The

balance of the chapter includes specific details for configuring and

wiring each type of I/O module.

In This Chapter

3.1 Module Placement ........................................................................... 3-2

3.2 Wiring ............................................................................................... 3-2

3.3 Isolated Digital Input (DI) Module .................................................... 3-5

3.4 Isolated Digital Output (DO) Module .............................................. 3-10

3.5 Non-isolated Digital Input/Output (DI/O) Module ........................... 3-14

3.6 Non-isolated Analog Input/Output & Analog Input Module ............ 3-17

3.7 Non-isolated High Speed Counter (HSC) Input Module ................ 3-21

3.8 Isolated Analog Input (AI) Module ................................................. 3-25

3.9 Isolated Analog Output (AO) Module ............................................. 3-29

3.10 Non-isolated Mixed I/O (MI/O) Module .......................................... 3-32

3.11 Isolated Vac Digital Input Module .................................................. 3-38

3.12 Relay Isolated Vac/Vdc Digital Output Module .............................. 3-40

3.13 Isolated Digital Input/Output (DI/O) Module................................... 3-42

3.14 Isolated Resistance Temperature Device (RTD) Input Module ..... 3-45

3.15 Isolated Low Level Analog Input (LLAI) Module ............................ 3-48

3.16 Non-isolated HART

/BTI Interface Module ................................... 3-53

3.17 IEC62591 Interface Module ........................................................... 3-61

Installation

Installing any I/O module in the ControlWave Micro involves the same

basic steps:

1. Remove the I/O module and associated I/O module cover from the

shipping carton.

Note: Modules normally ship from the factory completely

assembled.

2. Align the I/O module with its intended slot on the base or expansion

housing and slide the module into the housing. Make sure the

module snaps into the appropriate securing notches on the housing.

3. Wire and plug the local or remote cable assemblies into the

appropriate module connectors.

4. After installing and wiring two I/O modules into adjacent slots in

the housing, cover the modules with a protective bezel. The bezels

snap on and off for maintenance.

5. Using a PC running the ControlWave Designer and OpenBSI

software, configure the ControlWave Micro to accept the new I/O

modules and download the revised ControlWave project.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 169 170

Comments to this Manuals

No comments

Emerson ControlWave MICRO Instruction Manual Page 55

Comments to this Manuals

Related products and manuals for Power supply units Emerson ControlWave MICRO