Emerson ControlWave MICRO Instruction Manual download pdf (Page 14)

ControlWave Micro Instruction Manual (CI-ControlWave Micro)

1-10 Introduction Revised Jun-2013

maximum wire size of #14 AWG. All I/O modules have surge

protection that meets C37.90-1978 and IEC 801-5 specifications. Each

I/O module connects to the backplane using a 36-pin male card-edge

connector. All I/O modules are provided with two 10-point terminal

block assemblies (for local termination) or two 14-pin mass Termination

headers (for remote termination).

All digital (or discrete) I/O modules have individual point LED status

indicators that you can enable either with a jumper on the module or

through a software setting.

Figure 1-7. Two ControlWave Micro I/O Modules (with Bezel)

1.8 Software Tools

The ControlWave programming environment consists of a set of

integrated software tools which allow you to create, test, implement,

and download complex control strategies for use with the ControlWave

Micro. Figure 1-8 graphically presents the programming environment.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 169 170

No comments

Emerson ControlWave MICRO Instruction Manual Page 14