Emerson Liebert ICOM-DO Installation Manual download pdf (Page 16)

Inspection and Unpacking

3.5 Removing the Piano Jacks

1. Remove the piano jack strapping and pull the piano jacks away from the unit.

2. Remove all material used for panel protection.

3. The unit is now resting on the wooden spacer boards.

4. Remove jam nut from the four (4) stabilizer feet before continuing this step.

5. Lower the four stabilizer feet so that they contact the ground. Use either a 15/16" open-end

wrench or pliers. Fit the tool into openings in the ends of the base.

6. Turn the stabilizer feet one to two additional turns, removing the unit weight from the wooden

spacer boards.

7. Remove the wooden spacer boards from under the unit.

8. Using the stabilizer feet, slowly lower the unit until the unit casters are on the ground.

9. Open the top panel door with the mounted control.

10. Locate the bottom baffle panel assembly and reattach it to the unit with screws using a standard

screwdriver.

11. Close and latch the top panel door.

12. Two or more trained personnel can roll the unit on its casters to the installation site.

Steps 4 - 8

Steps 9 - 11

Step 12

Steps 1 - 3

REMOVE

JAM NUT

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 87 88

No comments

Emerson Liebert ICOM-DO Installation Manual Page 16