Emerson Liebert ICOM-DO Installation Manual download pdf (Page 14)

Inspection and Unpacking

3.2.1 Handling the Unit While it is Packaged

Figure 7 Recommended unit handling equipment

• If possible, transport the packaged Liebert CRV using a forklift or pallet jack; otherwise, use a

crane with slings and spreader bars.

• If using a fork lift or pallet jack, make sure the forks (if adjustable) are spread to the widest allow-

able distance that fits under the pallet. Make sure the fork length is suitable for the unit length.

• When moving the packaged unit with a forklift or pallet jack, lift the unit from either end of the

pallet.

• When handling the packaged Liebert CRV with a forklift or pallet jack, do not lift it any higher

than 2" to 4" (51mm to 102mm) off the ground. Any personnel not directly involved in lifting the

unit must be at least 12 ft (3.7m) from the unit.

• Exercise great care if the unit must be lifted higher than 4" (102mm); any personnel not directly

involved in lifting the unit must be at least 20 ft (5 m) away from the unit.

3.3 Unpacking the Liebert CRV

1. Remove the exterior stretch wrap packaging material from the unit, exposing the protective

corner and side packaging planks.

2. Remove the corner and side packaging planks from the unit, exposing the bag over the unit. The

bag may remain in place for dust and panel protection, or removed for immediate unit

installation.

3. Remove the bag when ready to install the unit.

Figure 8 Unpacking the Liebert CRV

Spreader Bars and Slings

Piano Jacks

Pallet

Jack

Forklift

Step 1 Step 2 Step 3

1 ... 13 14 15 ... 88

No comments

Emerson Liebert ICOM-DO Installation Manual Page 14