Emerson GXT4 User's Guide download pdf (Page 19)

Installation

13 Liebert

GXT4

™

Figure 10 Rotate the operation and display panel

c. Pull the logo on the front plastic bezel cover gently, rotate it 90 degrees clockwise and snap it

back into position. The rotated front plastic bezel cover is shown in Figure 11.

d. Replace the front plastic bezel cover on the Liebert GXT4. At this point, the UPS operation

and display panel and logo have been rotated 90 degrees clockwise, which provides upright

viewing for users.

5. Place the Liebert GXT4 and any battery cabinets on the support bases. Each Liebert GXT4 needs

two support assemblies, as shown in Figure 11.

Figure 11 Tower installation

2.4.2 Rack Installation

The Liebert GXT4 UPS and external battery cabinets (EBC), when installed in a rack enclosure, must

be supported by a shelf or rack-mount rails. The Liebert GXT4 UPS and EBC units ship with all

required hardware to allow rack-mount installation (not included with model numbers that end in

“E”). Because different rack-mount options install differently, refer to the installation instructions

provided with the rack mount kit being used.

Rotate Operation and

Display Panel

90 degrees clockwise

Operation and

Display Panel

Rotated for

Tower Operation

Support

Bases

Support

Bases

Liebert GXT4 UPS

Liebert GXT4 UPS and

External Battery Cabinet

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 55 56

No comments

Emerson GXT4 User's Guide Page 19