Emerson CF3300ORH Owner's Manual download pdf (Page 6)

CEILING

CANOPY

DOWNROD

EXTENSION

HANGER BALL

CLEVIS PIN

SETSCREW

1/4 x 10mm ROUND

HEAD SCREW (4)

Figure 6

10. Route the motor lead wires and support wire

through the downrod extension and the hanger

ball (Figure 6). For maximum wire clearance, the

support cable should be routed on one side of the

clevis pin and the electrical wires on the opposite

side of the pin.

11. Securely attach the downrod to the downrod

extension/hanger ball using the four 1/4 x 10mm

round head screws (supplied in the downrod

assembly bag) (Figure 6). The round head screws

must be fully tightened into the downrod

extension. A loose downrod will result with fan

assembly noise and vibration.

12. Be sure the hanger ball setscrews are securely

tighten at this time.

13. The fan comes with blue, black and white leads

that are 80-inches long. Before installing the fan,

measure up approximately 6 to 9-inches above

top of hangerball/downrod assembly. Cut off

excess leads and strip back insulation 1/2-inch

from end of leads.

14. Downrod assembly is now complete.

Electrical Requirements

The fan hanger bracket assembly shall be supported

directly from the supporting building structure. An

electrical box is not acceptable for fan support. The

building structure must be capable of supporting a

load of at least 100 pounds. Consult a qualified

professional to determine if your installation meets the

structural requirements.

Your new ceiling fan will require a grounded electrical

supply line of 120 volts AC, 60 Hz, 15 amp circuit.

To avoid fire or shock, follow all wiring

instructions carefully.

Any electrical work not described in these

instructions should be done or approved by a

licensed electrician.

WARNING

To avoid possible electrical shock, be sure

electricity is turned off at the main fuse box

before wiring.

NOTE: If you are not sure if the outlet box is

grounded, contact a licensed electrician for

advise, as it must be grounded for safe

operation.

WARNING

U.L. Model No.: CF3300

How to Hang Your Ceiling Fan

FLOOR

CEILING

LEAST

Figure 7

The fan must be hung with at least 7' of

clearance from floor to blades (Figure 7).

WARNING

Support directly from building structure.

Structure must be capable of reliably

supporting 100 pounds.

WARNING

IMPORTANT

Do not attach fan blades to fan assembly until the

fan assembly is securely installed to the ceiling.

Hanging the fan with blades attached may result

in damage to the fan blades.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

Emerson CF3300ORH Owner's Manual Page 6

Comments to this Manuals

Related products and manuals for Household fans Emerson CF3300ORH