Emerson CF3300ORH Owner's Manual download pdf (Page 4)

U.L. Model No.: CF3300

How to Put Your Ceiling Fan Together

HAIRPIN

CLIP

CLEVIS PIN

DOWNROD

COUPLING

DOWNROD

EXTENSION

5/16-18 x 1/4" CUP

POINT SETSCREW (2)

Figure 1

OFF

K. HANGER BRACKET

ASSEMBLY

M. SW22

WALL

CONTROL

A. FAN

ASSEMBLY

B. FAN MOTOR

COVERS (2)

H. RIGHT HAND

BLADE FLANGES (4)

C. DECORATIVE DOWNROD

SLEEVE ASSEMBLY

G. CEILING

CANOPY

M. MOUNTING

BRACKET BAG

N. HARDWARE

BAG

O. FLANGE

ASSEMBLY

BAG

P. BLADE

ASSEMBLY

BAGS

Q. DOWNROD

ASSEMBLY

BAG

F. DECORATIVE

STRAP RING

D. UPPER

DECORATIVE

DOWNROD SLEEVE

I. LEFT HAND BLADE

FLANGES (4)

L. BLADE

MEDALLIONS (8)

E. DOWNROD

EXTENSION

J. HANGER BALL/

DOWNROD

EXTENSION

1. Loosely install both 5/16-18 x 1/4” cup point

setscrews (supplied) into the downrod coupling.

Separate, untwist and unkink the three 80” motor

leads and support wire. Route the motor lead wires

and support wire through the downrod extension.

Align the clevis pin holes in the downrod extension

with the holes in the downrod coupling. Install the

clevis pin and secure with the hairpin clip

(Figure 1). The clevis pin must go through the

holes in the downrod coupling and the holes in the

downrod extension. Be sure to push the straight leg

of the hairpin clip through the hole near the end of

the clevis pin until the curved portion of the hairpin

clip snaps around the clevis pin. The hairpin clip

must be properly installed to prevent the clevis pin

from working loose. Pull on the downrod extension

to make sure the clevis pin is properly installed.

2. While pulling up on the downrod extension,

securely tighten the two setscrews in the downrod

coupling using the 3/16” hex wrench (supplied).

The setscrews must be tightened into the downrod

extension. A loose extension downrod will result

with fan assembly noise and vibration.

It is critical that the clevis pin in the downrod

coupling is properly installed and the

setscrews securely tightened. Failure to verify

that the pin and setscrews are properly

installed (as shown in Figure 1) could result in

the fan falling.

WARNING

NOTE: For ease of installation, loosely tape the

ends of the motor leads and the support wire

together to route through downrod during fan

installation.

3. Route the motor leads and support wire through

the downrod (Figure 2).

4. Securely attach the downrod to the downrod

extension using the four 1/4 x 10mm round head

screws (supplied in the downrod assembly bag).

The round head screws must be fully tightened into

the downrod extension. A loose downrod will result

with fan assembly noise and vibration.

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments

Emerson CF3300ORH Owner's Manual Page 4

Comments to this Manuals

Related products and manuals for Household fans Emerson CF3300ORH