Emerson ASCO 5350 Eight-Channel Remote Annunciator Installation Manual download pdf (Page 9)

ASCO 5350 Installation Manual

381333-315 D ASCO Power Technologies Page 9

5. When all ATS configurations are made, click Save to

upload the configuration to the ATS Remote Annunciator.

An Uploaded Successfully screen should appear. See

Figure 22. The ATS Remote Annunciator should now be

monitoring the ATSs (observe the status lights).

Figure 22: Updated Successfully screen

2-2 Multiple ATSs connected to one CM

In this mode, there is a single Connectivity Module for

multiple ATSs (that are daisy chained together). Therefore the

configuration is for one IP address (as assigned by the network

architect or administrator). Refer to the Figure 23.

Figure 23: Multiple ATSs connected to one CM

1. Perform step 4 on page 8 (Figures 19, 20, 21). All ATSs

must be of the same series (same controller).

2. Click the Save button to save the configuration.

2-3 Configuring Power Manager Alarms

If a Power Manager (PM) is provided with an ATS, the PM’s

eight Status Inputs can be configured to signal an alarm at the

ATS Remote Annunciator. At the PM, the Status Input must

be set to ACTV (on). Refer to PM manual 381333-199.

1. Be sure that a PM Address has been set (Figure 21). Then

click the Configure button (Figure 23) next to PM Address

2. The first row (top) is for PM Status Input 1. Click Enabled.

3. Next, enter a name in the Digital Input column, if desired.

4. Repeat steps 2 and 3 for each PM Status Input that is

ACTV (on). The second row is Status Input 2, etc. See

Figure 24.

5. Click the Update button to save these configurations.

6. Click the Save button to save all configurations to the ATS

Remote Annunciator. See Figure 22.

Figure 24: PM Status Input configuration

2-4 Print label

After the configurations are done and saved, you can print

custom labels for the ATS Remote Annunciator (Figure 1 on

page 2). A printer must be connected to the laptop computer

that is used for setting the configurations. Click the Print

Labels button at the bottom of the screen. See Figures 22 and

25.

Figure 25: Print labels screen

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Emerson ASCO 5350 Eight-Channel Remote Annunciator Installation Manual Page 9