Installation Manual ASCO 5350
Page 2 ASCO Power Technologies 381333-315 D
Specifications
Power Requirements: 120-220 V ac nominal
(90-264 V ac)
auxiliary 24 V dc nominal (9-36 V dc)
can be a battery or UL rated
Class 1 dc power supply
max. power 10 watts ac or 5 watts dc
Dimensions: 7.77” H x 9.95” L x 2.563” D
(19.74 cm H x 25.27 cm L x 6.51 cm D)
Weight: 2.7 lb. (1.2 kg)
Ethernet Communication Cable Requirements:
Belden 1583A or equiv. UTP CAT 5e or CAT 6
with RJ45 connectors (untwisted pair or higher)
Ethernet Port Connectors:
Two built-in 10/100 Base T (RJ45) 10/100 Mbps
Configuration Parameters:
(The parameters required to make an Ethernet connection)
IP Address 169.254.1.200
Subnet Mask 255.255.0.0
Gateway 0.0.0.0
TCP Port No. 10001
A label on the back shows the default settings.
Protocol Support: ASCO I, II, and Modbus/TCP
Ambient Temperature:
Operating -4 to 158 deg F (-20 to 70 deg C)
@ 5-85 % humidity
Storage -40 to 185 deg F (-40 to 85 deg C)
Number of Channels 8
Internal Alarm Buzzer
Alarm Relay Contact Ratings
contact configuration 1 spst normally open
ac ratings 1 A @ 110/220 V ac 50/60 Hz
1 Factory Default Information
A label on the back to the ATS Remote Annunciator lists
several important settings that you will need to do the
configuration. Write down this information below before
installing it (and after changing these settings).
IP Addr ______________
factory default: 169.254.1.200
Login ______________
factory default: admin and user
(see page 4 for Login names)
Password ______________
factory default: ASCO (capital letters)
Configured IP Address ___ ___ ___ ___
factory default: 169.254.1.200
(customer’s IP address)
2 Custom ATS Labels
Custom ATS names (instead of numbers) can be added to the
faceplate. See page 6 to enter and print customized names. To
install the custom labels follow these steps:
1. Remove the bezel by using a blade screwdriver. Insert the
screwdriver tip into the four slots between the bezel and
faceplate. Flip the screwdriver to remove the bezel.
2. Slide out the existing ATS labels. Cut the new custom
labels to fit and paste them onto the label holder. Then
slide them back onto the faceplate.
3. Reinstall the bezel by carefully aligning it, then pressing it
in firmly by hand until it snaps on (four places).
Figure 1: Custom ATS names (slide in labels)
face
late
bezel release
label
bezel
(222 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals