Emerson VSG & VSSG Installation Manual download pdf (Page 91)

6 – 3

VSG/VSSG • Installation, Operation and Maintenance Manual •Vilter/Emerson • 35391SSG

Slide Valve Actuators communicate problems discovered by internal diagnostics via LED blink codes. Only one blink

code is displayed, even though it is possible that more than one problem has been detected.

Flash Pattern Meaning

*=ON

_=OFF

*_*_*_*_*_*_*_*_*_*_*_

Calibration step 1

*___*___*___*___*___

Calibration step 2

*__*________________

This indicates a zero span. This error can only occur during calibration. The typi-

cal cause is forgetting to move the actuator when setting the upper limit of the

span. If this is the case, press the blue button to restart the calibration proce-

dure. This error can also occur if either or both of the slotted optocouplers are

not working. If this is the case, the slide valve actuator will have to be replaced.

The operation of the slotted optocouplers is tested as follows:

1. Manually rotate the motor shaft until the aluminum photochopper fence is

not blocking either of the optocoupler slots.

2. Using a digital multi-meter, measure the DC voltage between terminal 3 of

the small terminal block and TP1 on the circuit board (see Note 1). You should

measure between 0.1 and 0.2 Volts.

3. Next, measure the DC voltage between terminal 3 and TP2 on the circuit

board. You should measure between 0.1 and 0.2 Volts.

*__________________

This indicates a skipped state in the patterns generated by the optocouplers as

the motor moves. This error means that the slide valve actuator is no longer

transmitting accurate position information. The actuator should be recalibrated

as soon as possible. This code will not clear until the actuator is recalibrated.

This code can be caused by:

1. The motor speed exceeding the position sensors ability to measure it

at some time during operation. A non-functioning motor brake is usually to

blame.

2. The actuator is being operated where strong infrared light can falsely

trigger the slotted optocouplers, such as direct sunlight. Shade the actuator

when the cover is off for service and calibration. Do not operate the actuator

with the cover off.

Section 6 • Troubleshooting

Table 6-2. Slide Valve Actuator LED Blink Codes* (1 of 2)

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 105 106

No comments

Emerson VSG & VSSG Installation Manual Page 91