Emerson Liebert CW User Manual download pdf (Page 32)

Equipment Inspection and Handling

4.2.1 Removing the Unit from the Skid With a Forklift

1. Align a forklift with either the front or rear side of the unit (see Figure 21).

2. Insert the tines of the forklift completely under the base of the Liebert CW.

3. Remove the brackets holding the Liebert CW to the skid.

4. Lift the unit off the skid—no more than 4" (1052mm)—and remove the skid.

Figure 21 Remove the unit from the skid

WARNING

Risk of improper moving. Unit can tip over and cause equipment damage, injury or death.

Use the center of gravity indicators on the unit to determine the entry points for the tines (see

Figure 23). The center of gravity varies depending on the unit size and selected options.

The forklift’s tines must be equally spaced on either side of the center of gravity indicator. The

forklift’s tines must be locked to the widest possible spread that will fit under the unit.

WARNING

Risk of improper moving. Unit can tip over and cause equipment damage, injury or death.

Ensure that the tines are level—not angled up or down.

The tines must be at a height that will allow proper clearance under the unit.

Ensure that the tines extend beyond the opposite side of the unit.

Step 1

Step 2

Step 3

196713

Rev. 0

Step 4

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 87 88

No comments

Emerson Liebert CW User Manual Page 32