Emerson Liebert GXT3 User Manual download pdf (Page 20)

Installation

8. Fasten inner members pulled from the bracket assemblies in Step 2 to the UPS on both sides with

eight M4 screws provided in this kit. Make sure that the retaining latch is near the rear of the

UPS, as shown in Figure 14.

Figure 14 Installing inner members

9. Use M4 screws to install ears of accessories on both sides of the UPS, as shown in Figure 15.

Figure 15 Installing rack-mount ears

10. Insert the UPS, with inner members attached, into bracket assemblies by inserting top and

bottom edges of inner members into the top and bottom curved tracks of front members and

sliding the UPS into the rack, as shown in Figure 16.

Figure 16 Insert the UPS

NOTE

Ends of inner members are tapered to allow the rear of the UPS to be angled upward before

insertion, if space allows.

The UPS should move smoothly into the bracket assemblies. If not, recheck alignment of front

and rear members from Steps 4 through 7.

M4 screw

, 8 pieces

Retaining Latch

Liebert GXT3 UPS

Inner Member

M4 Screw

, 8 pieces

Ear,

2pieces

Liebert GXT3 UPS

Inner Member

Front Member

Insert

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 45 46

No comments

Emerson Liebert GXT3 User Manual Page 20