Emerson Liebert GXT3 1000VA User Manual download pdf (Page 18)

Installation

They are interchangeable between left-hand and right-hand. Mounting hardware includes M4

screws and M5 screws.

2. Remove inner member of each bracket assembly by extending it to its outermost position,

depressing the retaining latch and then pulling the inner member from the bracket assembly (see

Figure 10).

Figure 10 Pulling inner member from each bracket assembly

3. Determine the desired height and mounting position of the Liebert GXT3 inside the rack’s vertical

rails.

4. Attach the rear member of each bracket assembly to the rack’s vertical rails with two factory-

supplied M5 screws (see Figure 11).

Figure 11 Installing rear member of each bracket assembly

5. Extend bracket assembly by sliding the front member forward until it touches the rack’s front

vertical rails (adjustable length: 18 inches to 32 inches).

6. Use two M5 screws to attach each front member onto the front vertical rails through the

installation holes. Make sure that the bracket assemblies are at the same mounting height on all

four of the rack’s vertical rails (see Figure 12.)

CAUTION

Reduce risk of tipping the rack by installing the Liebert GXT3 in the lowest possible rack

position.

Inner member

Bracket assembly

Retaining latch

M5 screw (4 pcs)

Vertical pole

Rear member

Front member

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

No comments

Emerson Liebert GXT3 1000VA User Manual Page 18