Emerson Liebert GXT3 1000VA User Manual download pdf (Page 17)

Installation

Figure 8 Rotate the operation and display panel

c. Pull the logo on the front plastic bezel cover, rotate it 90 degrees clockwise and snap it back

into position. The rotated front plastic bezel cover is shown in Figure 9.

d. Replace the front plastic bezel cover on the Liebert GXT3. At this point, the UPS operation

and display panel and logo have been rotated 90 degrees clockwise, which provides upright

viewing for users.

5. Place the Liebert GXT3 and any battery cabinets on the support bases. Each Liebert GXT3 needs

four support bases, as shown in Figure 9.

Figure 9 Tower installation

2.4.2 Rack Installation

To install a Liebert GXT3 UPS in a rack:

1. Unpack the two bracket assemblies and mounting hardware from the rack-mounting kit

(P/N: RMKIT18-32). Bracket assembly includes inner member, front member and rear member.

NOTE

• When the Liebert GXT3 is installed in a rack, the UPS must be supported by a shelf,

brackets, or slide rails on each side. The factory-supplied rack-mount ears cannot support

the weight of the UPS. They are used to move the UPS into and out of the rack and attach the

UPS to the rack.

• Mounting hardware and slide rails are sold separately. Contact your local dealer or

Emerson representative for these options and any assistance.

Operation and Display Panel

Rotated Clockwise 90 Degrees

Operation and

Display Panel

Rotated for

Tower Operation

Support Bases

Liebert GXT3 UPS

Liebert GXT3 UPS and

External Battery Cabinet

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

No comments

Emerson Liebert GXT3 1000VA User Manual Page 17