Emerson E2 User Manual download pdf (Page 131)

License Management Quick Start • 10-19

five seconds.

10.14.2.2 The Manual ID Entry Method

The Manual ID Entry Method involves entering each

device’s twelve-digit ID number by hand. When entered,

the E2 searches the network and tries to match the ID

number to the device. When the E2 finds this device, the

commissioning process is completed.

The easiest way to set up a multiple-node store using

the Manual ID Entry Method is to arrange all network

devices into a list that shows each device’s name, subnet

and node address, controller type, and corresponding Neu-

ron ID number. Once this list is complete, each device

may be commissioned one at a time from the E2 front

panel.

To make a list of network devices, follow the steps

below:

1. For each record set up in the Controller Network

Configuration/Status Screen, write down the con-

tents of each device’s Controller Name, Model,

Subnet, and Node fields on a sheet of paper. If

desired, you may also include the model or serial

numbers of the units that will be controlled, as

well as a physical location.

2. When step 1 is complete, go to where each device

on the list is installed and locate each device’s

Neuron ID sticker. Every Echelon-compatible

device available from Retail Solutions has a

sticker on its enclosure that shows the unit’s Neu-

ron ID number. Each sticker also has a perforated

tag at the bottom that may be removed and

affixed to your form. Tear this tag off and stick it

in the Neuron ID blank on the sheet of paper. If

the perforated tag has already been removed,

write the ID number in the blank.

When all Neuron ID numbers have been collected,

return to the E2 and enter the Neuron ID numbers for each

device. To commission a device, move the cursor to the

device to be commissioned and press  (Set Address).

A menu will appear on the screen, giving you the

option of either pressing the service button, entering the

Neuron ID by hand, or cancelling and returning to the

main screen. Press

 to select the manual entry option

and bring up the dialog box shown in Figure 10-32.

Enter the device’s Neuron ID as it appears on the form

you created, and press

. The E2 will then look for

the controller with the Neuron ID you entered. If it is

found, the E2 commissions the device, and you may move

on to commissioning the next device.

If E2 does not find it, the display will read “ERROR -

Controller with specified Neuron ID did not respond.”

This could be caused by an improperly entered number, or

it could be caused by a problem with the device’s network

connections or power connections.

When all devices are commissioned, keep the form

with the Neuron ID stickers in an easily accessible place

so that it may be referred to if necessary for board remov-

als, replacements, or troubleshooting.

10.15 License Management

Some applications in the E2 are only available when

activated with a license key that is obtained through Retail

Solutions. Licensing allows the user to activate certain

features in the E2.

To obtain a license for a feature, go to the TCP/IP

setup screen and obtain your E2 controller’s MAC

Address. Press

 + T, or from the Main Menu:

1. Press

 (System Configuration)

2. Press

 (Remote Communications)

3. Press

 (TCP/IP Setup) to open the TCP/IP

Setup screen and locate your E2’s MAC address

(circled in Figure 10-33):

Figure 10-31

- Commissioning Menu

Figure 10-32 - Setting Controller Address - Neuron ID

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 272 273

Comments to this Manuals

No comments

Emerson E2 User Manual Page 131

Comments to this Manuals

Related products and manuals for Thermostats Emerson E2