Emerson CF890BS00 Owner's Manual download pdf (Page 18)

ETL Model No.: CF890

7. Wall Control Procedures (continued)

PROGRAMMING THE RECEIVER

OPERATING FREQUENCY & HIGH SPEED

CONDITIONING OF FAN CONTROL

IMPORTANT: Ceiling fan blades MUST be installed

before high speed conditioning can begin.

7.24

Within 1 minute of restoring electricity to the ceiling fan,

push and hold the fan OFF button ( ) for 3 to 5

seconds to set the code in the receiver. The ceiling fan

lights (if installed) will blink to indicate the transmitted

has been paired with the receiver.

IMPORTANT: Immediately after successful pairing,

the ceiling fan will automatically begin high speed

conditioning of the motor. During conditioning, the

electronic motor control software is calculating

speeds for the 2nd through 5th speed settings

based on the blades that were installed on the fan.

7.25

The fan will run for approximately 2 minutes in the

upward direction then reverse direction to down flow

and run an additional 2 minutes. When conditioning is

complete, the fan will come to complete stop.

USING YOUR CEILING FAN

Your wall control has full control of your fan and light.

NOTE: Prior to operation of the fan and light from

the wall control, set the fan speed to HIGH (

....

) and

turn the light ON ( ).

7.29

To set the desired fan speed, press one of the four

buttons (

...

....

) to operate your fan on from low to

high speeds (Figure 26).

7.30

To turn the light on and off, press and release the

LIGHT ( ) button. To set the light intensity, press and

hold the LIGHT ( ) button. The light will turn on at the

light intensity previously selected.

7.31

Your fan is now wired to be turned on and off from the

fan switch.

IMPORTANT: Do not interrupt the conditioning until

the fan comes to a complete stop in approximately 5

minutes. All functions of the control will be rejected

during conditioning.

7.26

High speed conditioning is now complete.

7.27

If programming is unsuccessful, retry the above

instructions after cycling the wall control ON/OFF switch

to restart the 1 minute programming time period.

7.28

If still unsuccessful, shut off the electricity at the fuse

box or breaker panel and change the wall control

frequency (page 14). After changing the frequency

settings, repeat instruction #1 of this section within one

minute of restoring the electricity.

Fan installation must be completed, including the

installation of the fan blades, before testing the remote

control.

WARNING

OFF ON

....

HIGH TO LOW

BUTTONS

ON/OFF SWITCH

O = OFF / — = ON

LIGHT BUTTON

FAN BUTTON

POWER

INDICATOR

LIGHT

Figure 26

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Emerson CF890BS00 Owner's Manual Page 18

Comments to this Manuals

Related products and manuals for Household fans Emerson CF890BS00