Emerson CF890BS00 Owner's Manual download pdf (Page 14)

ETL Model No.: CF890

7. Wall Control Procedures (continued)

7.3

Your wall control has code switches which must be set

in one of 32 possible code combinations (Figure 21).

The five levers (numbered 1, 2, 3, 4, and 5) on the

switches are factory-set in the ON (up) position.

Change the switch settings as follows:

7.4

Slide the five switch levers in the wall control to your

choice of ON (up) or down positions. Use a ball-point

pen or small screwdriver and slide the levers firmly up

or down.

7.5

The sixth switch marked ON and I is for dimming

control of lights: Set switch to ON to allow for dimming

of the lights. Set switch to I for no dimming of the lights

such as for fluorescent bulbs and non-dimming CFLs.

SINGLE-POLE INSTALLATION

WALL CONTROL

CODE SWITCHES

CODE

SWITCHES

WALL

CONTROL

Figure 21

EMERSON

MED

LOW

FAN OFF

LIGHT

ONOFF

FAN/LIGHT

WALL CONTROL

HOT BLK

NEUTRAL

BLACK

GROUND

LOAD

BLACK

RECEIVER LOCATED ON

TOP OF THE CEILING

FAN

OFF ON

....

Figure 22

Turning off wall switch is not sufficient. To avoid

possible electrical shock, be sure electricity is turned

off at the main fuse or circuit breaker box before

wiring. All wiring must be in accordance with National

and Local codes and the ceiling fan must be properly

grounded as a precaution against possible electrical

shock.

WARNING

CAUTION: To reduce the risk of electrical shock,

disconnect the electrical supply circuit before

installing the fan, light kit or receiver.

NOTE: Make all wiring connections using wire

connectors (supplied). Make sure that all

connections are tight, including ground, and that no

bare wire is visible at the wire connectors, except

for the ground wire.

7.6

Disconnect electrical power to the branch circuit at the

circuit breaker or fuse box before attempting to install

the ceiling fan wall control into the outlet box.

7.7

Remove faceplate and screws from existing wall control.

Pull control out from the wall box. Determine the “hot”

wire and the “load” wire and disconnect these wires

from control (Figure 22). Do not attempt to disconnect

any wires not already connected to existing control.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comments to this Manuals

No comments

Emerson CF890BS00 Owner's Manual Page 14

Comments to this Manuals

Related products and manuals for Household fans Emerson CF890BS00