Emerson Liebert MicroPOD Maintenance Bypass and Output Distribution Accessory User's Guide download pdf (Page 15)

START EQUIPMENT

1. Turn on all loads hardwired to the output of the POD. The 2U

POD now powers your equipment in the UTILITY mode.

2. Turn ON the loads and ensure all are up and operating properly.

3. Start the UPS according to its specific user manual.

4. Verify that the UPS lamp (green) on the 2U POD is illuminated. If

so, transfer the rotary switch from UTILITY to UPS. The load is

now being supplied with conditioned power through the UPS.

5. Before any operation or procedure, always verify that both the

UPS lamp (green) and the UTILITY lamp (amber) are illuminated

before changing the status of the rotary switch.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

No comments

Emerson Liebert MicroPOD Maintenance Bypass and Output Distribution Accessory User's Guide Page 15