Emerson SW90 Owner's Manual download pdf (Page 2)

Installation

NOTE: Installation of this control

requires that a three-conductor cable

with ground wire be run between the

control wall box and the ceiling fan

outlet.

1. After electricity has been turned off at

the main fuse box or circuit breaker

panel, remove the existing wall plate

and switch (Figure 1).

Safety Instructions

WARNING: To avoid fire, shock, and serious personal injury, follow all

instructions carefully.

1. Read your Owner's Manual carefully before installing the fan/light control.

Retain Owner's Manual for future reference.

2. To avoid possible electrical shock, be sure electricity is turned off at the

main fuse box or circuit breaker panel before wiring.

3. Make certain no bare wires are exposed outside the wire connectors.

4. Do not mount the fan/light control near heat producing equipment.

5. All wiring must conform to National and Local Electrical Codes. If you feel

you do not have enough electrical wiring knowledge or experience, have

your fan/light control installed by a licensed electrician. Any electrical work

not described in this manual should be performed by a licensed electrician.

6. Use of this control with some ceiling fans could result in fire, shock and

serious personal injury. Use this fan/light control only with capacitor speed

controlled ceiling fans.

2. Set all knobs on the fan/light control in

the off (down) position (Figure 2).

3. Make the following wire connections

(Figure 2) and secure with wire

connectors supplied:

• Black wire from fan to black wire from

fan/light control.

• White wire from fan to white wire

from the 120V AC supply source.

• Blue wire from fan to blue wire from

fan/light control.

• Black/white wire from fan/light control

to black wire from the 120V AC

supply source.

NOTE: Refer to Schematic “A” or “B”,

depending upon the location of your

120V AC supply source.

To avoid possible electrical shock,

be sure electricity is turned off at

the main fuse box or circuit

breaker panel before installing the

fan/light.

OUTLET BOX

SWITCH

WALL PLATE

EMERSON

TO HOT

BLACK/WHITE

SPEED

SWITCH

BLACK SPEED CONTROL LEAD

LIGHT

SWITCH

BLUE LIGHT SWITCH LEAD

BACK VIEW

DASH LINES ARE 3

CONDUCTOR CABLE

W/GROUND WIRE

BETWEEN CEILING

AND WALL OUTLET

BOXES

120V AC

SUPPLY

SOURCE

BLACK

WHITE

GROUND

GREEN

WHITE

BLACK

BLUE

WALL OUTLET

BOX GROUND

BLUE

BLACK

BLACK/WHITE

FAN/LIGHT

CONTROL

CEILING OUTLET BOX

Figure 1

Figure 2

Schematic “A”

CONNECTIONS REQUIRED WHEN SUPPLY VOLTAGE IS FED INTO CEILING

OUTLET BOX.

DASH LINES ARE 3

CONDUCTOR CABLE

W/GROUND WIRE

BETWEEN CEILING

AND WALL OUTLET

BOXES

GREEN

WHITE

BLACK

BLUE

120V AC

SUPPLY

SOURCE

BLACK

WHITE

GROUND

BLUE

BLACK

FAN/LIGHT

CONTROL

BLACK/WHITE

CEILING

OUTLET

BOX

Schematic “B”

CONNECTIONS REQUIRED WHEN SUPPLY VOLTAGE IS FED INTO WALL

OUTLET BOX.

WARNING

1 2

Comments to this Manuals

No comments

Emerson SW90 Owner's Manual Page 2

Comments to this Manuals

Related products and manuals for Household fans Emerson SW90