The Installation, Care and Use of Your New“Hot-1” HotWater Dispenser®Warnings alert you to hazards or unsafe practices which could result in severepe
A hot water dispenser, like any water heater, has limited lifeand will eventually fail. To avoid possible property damage, ahot water dispenser should
PLUG ORCAP1Let’s start the installationAIf you have a spray unit like this oneon your kitchen sink, the hole is per-fect for mounting your Hot-I Dis
2 1 2" (6.4cm)(10.2cm)2 9 16"(6.5cm)4"What if you don’t use a spray hole or don’t want to use it?You can cut a mounting hole thro
DO NOT plug in the electrical supply cord until the tank is full of water2‘A’Now we install the dispenserAMount the unit through the 1-3/8" dia.
DO NOT plug in the electrical supply cord until the tank is full of water3Where plumbing codespermit, a saddle valve (not supplied) can be used to sup
Once the electrical cord is plugged in, it willtake ten to 15 minutes for the water to reachits 190°F (88°C)* temperature.When the 190°F (88°C)* tempe
The thermostat is preset at the factory at approximately 190° F.If you wish to adjust the water temperature, turn the thermostatadjustment screw clock
Comments to this Manuals