Emerson 475 User Manual download pdf (Page 7)

Installing the System Card and battery

Figure 2. Back of the 475 Field Communicator

INSTALLING THE SYSTEM CARD AND BATTERY

If you received a 475 Field Communicator with the System Card already installed,

proceed to the "Starting the 475 Field Communicator" section.

1. Remove the protective rubber boot, if attached.

2. Place the 475 Field Communicator face down on a level, secure surface.

3. With the battery removed, slide the Secure Digital System Card (labeled System

Card), with the card contacts facing up, into the System Card socket until it clicks.

The System Card socket is spring-loaded. See Figure 2 for the System Card socket

location. The System Card is not locked into the System Card socket in Figure 2.

CAUTION

The System Card must be supplied by the 475 Field Communicator manufacturer.

Failure to comply will void the IS approval.

4. With the 475 Field Communicator still face down, ensure the two battery retaining

screws are loose.

5. Align the battery with the sides of the 475 Field Communicator, and carefully slide

the battery forward until it is secure.

CAUTION

The connector pins may be damaged if the battery and 475 Field Communicator are

improperly aligned.

6. Carefully hand tighten the two battery retaining screws. (Do not over tighten, 0.5Nm

maximum torque load.) The tops of the screws should be nearly flush with the 475

Field Communicator.

Battery retaining screws

Li-Ion battery

Connector pins

System Card partially

inserted in the System

Card socket

Main unit label

Strap attachment

IS label

(KL option)

Stand

Bluetooth approval label

475_Getting_Started_Eng.fm Page 7 Wednesday, May 28, 2014 2:18 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Emerson 475 User Manual Page 7