Model Solu Comp®Xmt-P-FF/FIFOUNDATION®Fieldbus Two-WirepH/ORP TransmitterInstruction SheetPN 51A-Xmt-P-FF-FI/rev.AJanuary 2006ESSENTIAL INSTRUCTIONSRE
10FIGURE 7. Loop Power and Sensor Wiring - Pipe/Surface Mount
MAIN MENUMENU TREE FOR MODEL SOLU COMP Xmt-P-FF/FI TRANSMITTER11
Credit Cards for U.S. Purchases Only.The right people,the right answers,right now.ON-LINE ORDERING NOW AVAILABLE ON OUR WEB SITEhttp://www.raihome.com
MODEL Xmt-P SPECIFICATIONS2SPECIFICATIONS - GENERALCase: ABS. panel mount, polycarbonate (pipe/surfacemount). Both versions are NEMA 4X/CSA 4 (IP65).
3MODEL Xmt-P SPECIFICATIONSSENSOR COMPATIBILITY CHARTpH/ORP SENSOR DIAGNOSTIC CAPABILITY320HP-58 Glass only328A Glass only370 Glass only 371 Glass onl
45. Choose measurement: pH, ORP, or Redox. 6. Choose preamplifier location. Select Xmtr to use the integral preamplifier in thetransmitter; select Sen
MODEL Xmt-P INSTALLATION5UNPACKING AND INSPECTIONInspect the shipping container. If it is damaged, contactthe shipper immediately for instructions. Sa
MODEL Xmt-P INSTALLATION6FIGURE 3. Panel Mount InstallationAccess to the wiring terminals is through the rear cover. Four screws hold the cover in pla
MODEL Xmt-P INSTALLATION7FIGURE 4. Pipe Mount InstallationThe front panel is hinged at the bottom. The panel swings down for access to the wiring term
8MODEL Xmt-P INSTALLATIONFIGURE 5. Surface Mount InstallationThe front panel is hinged at the bottom. The panel swings down for access to the wiring t
9MODEL Xmt-P INSTALLATIONFIGURE 6. Loop Power and Sensor Wiring - Panel Mount
Comments to this Manuals