Type 310AD102068X012Instruction ManualForm 5351March 2010
Type 310A10Pilot AdjustmentThe second-stage working regulator must be set to operate at a lower pressure than the monitoring pilot or the monitoring p
Type 310A11conditions and on applicable federal, state and local codes and regulations.!
Type 310A12 4. place the spring (key 36) in the piston guide (key 23).
Type 310A13 4. Slide the sleeve and diaphragm assembly out of the case body (key
Type 310A14
Type 310A151. In case the kit R310X000072 is for a size NPS 4 x 6 (DN 100 x 150) Type 310A, it is necessary to purchase an extra Wiper Ring (PN 1R752
Type 310A16 Repair Kits (Include keys 6, 9, 11, 19, 26, 27, and 29) (continued) With Fluorocarbon (FKM) O-rings
Type 310A17 2 Base Body, WCC steel (continued) Without travel indicator
Type 310A18 6* Diaphragm Nitrile (NBR) NPS 1 (DN 25) 1R747299982 NPS 2 (DN 50) 1R741099982 NPS 3
Type 310A19 19 Wiper Ring, Nitrile (NBR) (Not for use over 200°F (93°C)) NPS 1 (DN 25) 1R748204152 NPS 2 (
Type 310A21. The pressure/temperature limits in this Instruction Manual or any applicable standard limitation should not be exceeded.
Type 310AThe Emerson logo is a trademark and service mark of Emerson Electric Co. All other marks are the property of their prospective owners. Fisher
Type 310A3The regulator inlet pressure enters the pilot through the external pilot supply line
Type 310A4Wide-Open Monitors (Figure 4)Monitoring regulators serve as overpressure protection devices to limit system pressure in the e
Type 310A5functional. A restriction placed in the external tubing between the diaphragm loading pressure and the intermediate pressure acts as a down
Type 310A6InstallationA Type 310A-32A regulator bleeds no gas to atmosphere during normal operation, thus making the regulator
Type 310A7 7. Install a hand valve in the control line. 8. Install the other end of the downstream control line to the 1/2 NPT connectio
Type 310A8outlet pressure was factory-set at the mid-range of the pilot control spring. Before beginning the startup procedures in this section, make
Type 310A9Install the Type 310A-32A-32A into the pipeline using adequate gaskets for anged regulator units and good piping technique. Be sure to pro
Comments to this Manuals