Emerson CF960CK 00 User Manual download pdf (Page 9)

Using Your Ceiling Fan

1. Restore electrical power to the outlet box by turning

the electricity on at the main fuse box.

2. Check the operation of the fan by gently pulling on

the speed control pull chain switch (Figure 23). The

operating sequence is as follows:

THREE-SPEED

1st Pull—HIGH

2nd Pull—Medium

3rd Pull—Low

4th Pull—OFF

3. If airflow is desired in opposite direction, turn your

fan off and wait for the blades to stop turning, then

slide the reversing switch to the opposite position,

and turn the fan on again. The fan blades will turn

in the opposite direction and reverse airflow.

4. Check the operation of the light fixture by gently

pulling on the light control pull chain switch.

SPEED CONTROL

SWITCH

LIGHT CONTROL

SWITCH

REVERSING

SWITCH

Figure 23

9. Carefully cut the blue wire going to the light switch.

Strip off 1/2-inch of insulation and connect this blue

wire to the blue wire from the light fixture (Figure

21) using a wire connector (supplied).

10.Carefully cut the white wire going to the

two-wire connector. Strip off 1/2-inch of insulation

and connect this white wire to the white wire from

the light fixture (Figure 21) using a wire connector

(supplied).

11.Engage the connector from the light adapter

plate with the connector from the motor

assembly (Figure 15). The two connectors are

keyed and color-coded and must be mated

correctly (color-to-color) before they can be

engaged. Make sure the connector latch closes

properly.

12.Position the light adapter plate over the light

fixture mounting plate. The adapter plate switches

must be located in the recessed portion of the

mounting plate (Figure 15). Align the holes in the

adapter plate with the holes in the mounting plate

and install four 5/32-32 x 5/16” Phillips flat head

screws (supplied) (Figure 22).

13.Cut the speed control switch pull chain to your

desired length (optional). Connect the wood

pendant (supplied) to the pull chain by sliding the

wood pendant (small hole first) onto the pull chain

(Figure 22). Then attach a chain coupling

(supplied) to the end of the chain and allow the

pendant to slide down over the coupling.

TWO-WIRE

CONNECTOR

CONNECT TO WHITE

WIRE FROM LIGHT

FIXTURE

CUT WHITE

WIRE HERE

CONNECT TO BLUE WIRE

FROM LIGHT FIXTURE

CUT BLUE WIRE

HERE

LIGHT

SWITCH

Figure 21

To avoid possible fire or shock, make sure that the

electrical wires are not pinched between the light

adapter plate and the mounting plate.

WARNING

WOOD PENDANT

CHAIN COUPLING

ADAPTER PLATE

SWITCHES

5/32-32 x 5/16" PHILLIPS

FLAT HEAD SCREW (4)

LIGHT

ADAPTER

PLATE

Figure 22

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Emerson CF960CK 00 User Manual Page 9

Comments to this Manuals

Related products and manuals for Faxes Emerson CF960CK 00