Emerson MA 1200 User Manual

ProLink® IIInstallation and StartupQuick Reference GuideP/N 20001908, Rev. GAAugust 2009 For customer service, phone the support center nearest you:•

9• If you are connecting to any Model 2400S transmitter using the service port:- For point-to-point connections, you can use a service port connection

10Table 4. Model 2400S service port auto-detection limitsParameter OptionProtocol Modbus RTU (8-bit)Modbus ASCII (7-bit)Address Responds to both:• Ser

116. Click the Connect button. ProLink II will attempt to make the connection.• If you are making a service port connection to a Model 1700/2700, Mode

12• If you are connecting to a Model 1500/2500, Series 3000, or LFT DIN rail mount transmitter, the RS-485 terminals are available in service port mod

13

14

Micro Motion EuropeEmerson Process ManagementNeonstraat 16718 WX EdeThe NetherlandsT +31 (0) 318 495 555F +31 (0) 318 495 556Micro Motion United Kingd

1©2009, Micro Motion, Inc. All rights reserved. ELITE, ProLink, and the Micro Motion logo are registered trademarks of Micro Motion, Inc., Boulder, Co

2PC requirementsTo install and run ProLink II, your PC must meet or exceed the following requirements:• 200 MHz Pentium processor• One of the followin

3STEP 1. Install the ProLink II softwareTo install ProLink II software:1. Insert the ProLink II CD-ROM into the PC’s CD-ROM drive.2. If the setup prog

4STEP 2. Connect the PC to the transmitter1. Connect the appropriate signal converter to your PC’s serial or USB port, using adapters as required.• Fo

5Model 2400S with analog outputs12orHART clipsService port clipsModel 2400S with DeviceNetService port clipsModel 2400S with PROFIBUS-DPService port c

63. Add resistance if required. Many HART connections require added resistance. See Table 2. For additional information, see the ProLink II manual or

74. For Modbus network connections, ensure that ProLink II is the only Modbus master currently active on the network.There are additional methods for

8ProLink II will poll all addresses in the specified range, and populate the Found dropdown list with all Model 7826/7828 devices found in that range.