Emerson CKD9905 Owner's Manual download pdf (Page 6)

INSTALLATION

Unravel the AC cord and connect it to a

conveniently located AC outlet having

120V and 60Hz only. The Clock Display

will illuminate and “12:00” will appear in the

display.

NOTE: If the AC plug does not fit into a

nonpolarized outlet, do not file or cut the

wide blade.

If the AC cord is disconnected or if there is a power failure, this electronic clock is

designed to continue operating internally (without showing the time on the Clock

Display) with a 9 volt battery (not included). To install the battery, remove the

battery compartment cover and connect the battery to the terminals of the battery

snap inside the compartment (use of an alkaline battery is recommended) and

install the battery compartment cover back into place.

Be sure to check the condition of the battery periodically by disconnecting the AC

cord and connecting it again two to three minutes later. The preset times should

continue operating. If the present time resets to “12:00”, it indicates the battery is

dead or not connected properly. A fresh 9 volt battery will keep the internal times

accurately for approximately 40 hours continuously. If you experience only the

normal brief interruptions of AC power, the battery can last much longer. It is

recommended to install a new battery every eight to 12 months.

CKD9905 O/M.QXD 3/11/03 3:54 PM Page 6

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

No comments

Emerson CKD9905 Owner's Manual Page 6