Emerson ES13 User Manual download pdf (Page 10)

SETTING THE CLOCK

The clock should be set while the system is in the Standby mode (Power ‘Off’).

1.) Press and hold the TIME SET/MEMORY

button on the top panel for at least two

seconds. The hour digits and the AM/PM

indicator begin to flash.

2.) Press the TUNING (SET) or buttons on the top panel or on the remote

control to adjust the clock to the correct hour, AM or PM.

3.) Press the TIME SET/MEMORY button

once more. The minute digits begin to

flash.

4.) Press the TUNING (SET) or buttons on the top panel or on the remote

control to adjust the clock display to the correct minutes.

5.) Press the TIME SET/MEMORY button once more. The display will show

“12 H” meaning that the time will be displayed in ’12 hour format’

(6 PM = 6:00). If you prefer ‘24 hour format’ (6 PM = 18:00), press either the

TUNING (SET) or buttons on the top panel or on the remote control to

switch between “12H” and “24H” time formats.

6.) Press the TIME SET/MEMORY button

once more. The time display returns and

the clock begins to run.

The time will appear on the display whenever the system is in the Standby (Power

‘Off’) mode. The STANDBY LED lights up.

Note: If the AC power is disconnected for an extended period, the time memory

will be lost and the clock will have to be reset when power is restored.

ES13_draft090902.p65 9/9/2002, 17:379

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

No comments

Emerson ES13 User Manual Page 10